CaracterísticasThe first Rega turntables built during the 70’s carried a Rega designed Japanese built ‘S’ shaped tonearm called the R200. By 1983 the time had come for Rega to design and build its own tonearm and so the world famous RB300 (Rega Britain) was born. The high pressure die-cast silicon alloy tube alone took two years to develop alongside the UK’s largest die-cast company. The work and our casting subsequently won us an "international casting award" from America for what is still considered today to be a technically impossible casting. See if you can find one the same! Since its conception we have sold over 400,000 of the now legendary RB300 derived tonearm.
The award winning RB1000 takes almost twenty times longer to produce than an RB301. At present there are only two highly experienced technicians that can build this exotic tonearm.
A “blue printing” parts and assembly process is used resulting in zero tolerance engineered assemblies offering ultimate performance.
The bearings fit on to ground shafts and into the tonearm using interference fits. This means that no adhesive is required and therefore none of the associated (component - adhesive - component) losses in rigidity prevail. It is fitted to the plinth by a 3-point fixing which is CNC machined out of a single solid block of Stainless steel. This provides the strongest most rigid base structure possible for the tonearm and causes less stress on the plinth and the bearing housing, and therefore the least possible resonance.
The RB1000 carries more technological changes over previous Rega tonearms than any other Rega tonearm produced during the last twenty years! Key areas of improvement